Start / Stop

Start

1. Fuel

2. Canopy LCtrl + C LEFT 1

3. Lock Canopy LEFT 1

4. Arm Ejection Seat LEFT 1

5. Electrical Panel Main Power LEFT 2

6. JFS: Start 2 RPM: 20% LEFT 2

7. Throttle: Idle RShift + Home > RPM: 60%

Parking Brake LEFT 1

8. Avionics Power Panel All On (7x), Allign: Norm, MDS LVT: On RIGHT 3

9. Sensors Power All On (4x) RIGHT 2

10. Uncage SAI & Level

11. HUD Symbology (SYM) Set

12. Master Caution Off

13. UHF (Radio) MAIN LEFT 2

14. NWS On

15. Avionics Power Panel Allign > NAV (LIST > 6) RIGHT 3

IMPORTANT: You must either enter or confirm the latitude and longitude coordinates of your aircraft on the INS DED page within two minutes after starting an NORMAL alignment. Failing to do that within 2 minutes will result in a degraded INS alignment.

Turn MDS LVT to On after GPS Warmup

Stop

1. Throttle: Off RShift + End

2. JFS Run Light Verify Off LEFT 2

3. EPU GEN / PMG Verify Off LEFT 2

4. Main Power Off LEFT 2

5. Oxygen Off & 100% RIGHT 2

6. Canopy: Open LCtrl + C LEFT 1

1. Close the canopy and lower the lock (LCtrl + C)

2. Set battery to MAIN PWR

3. Set the UHF radio to MAIN or BOTH and tune frequencies

4. Set IFF Master Knob to NORM

5. Set the Jet Fuel Switch to START 2

6. Monitor the RPM gauge on the right side and once it reaches 20% move the throttle to IDLE (RShift + Home)

7. Monitor engine RPM until it reaches 65%

8. Uncage the Standby Attitude Indicator

9. Set interior and exterior lighting as desired

10. On the Avionics Power panel turn on the MMC, ST STA, MFD, UFC, MAP, GPS and DL on

11. Turn the MIDS LVT knob to ON

12. On the ICP set HUD Symbology Intensity as desired

13. Set the INS knob to STOR HDG or NORM

14. Monitor the INS page on the Data Entry Display and once the number after the / on the INS Line is below 10 and the RDY is flashing set INS Knob to NAV

15. Power on the RWR and switch the RWR, JMR, CH and FL switches up

16. Set Dispense mode as desired.

17. Turn the RDR ALT on

18. Set Stores Config as needed

19. Set Taxi lights as needed

20. Ensure no Cautions on the Warning panel

21. Arm the ejection seat

Mouse Wheel Front > Right Wise / Clockwise

Mouse Wheel Back > Left Wise / Counter-ClockWise